What Is S620Q Steel
S620Q is a high-strength structural steel defined in EN 10025-6, the European standard for flat products of structural steels in the quenched and tempered condition. The designation reads: S for structural, 620 for a minimum yield strength of 620 MPa, and Q for quenched and tempered delivery. The steel achieves its strength through full-section hardening rather than alloying alone, which preserves toughness and weldability at very high strength levels.
- 620 MPa minimum for thickness 3-50 mm; 580 MPa for 50-100 mm.
- 700-890 MPa for thickness 3-50 mm; 700-940 MPa for 50-100 mm.
- minimum 15% on the standard longitudinal test piece.
- 27 J minimum at -20 ℃ for the standard quality, with lower-temperature options available.
at a controlled temperature to restore toughness and adjust final strength. This process develops yield strengths of 620 MPa and above through the full thickness, with a fine-grained microstructure that resists brittle fracture. The same base chemistry can be tempered to different levels, producing the S460Q, S500Q, S550Q, S620Q and S690Q family.
- roughly 30-50% lighter sections than 355 MPa steel for the same load.
- less dead weight allows more lifting or carrying capacity in mobile equipment.
- the clean, fine-grained structure gives good behaviour under repeated loading.
- low carbon and controlled alloying allow welding with qualified procedures despite the high strength.
- booms, outriggers and chassis frames where weight saving drives capacity.
- dump truck bodies, buckets and structural frames in high-strength service.
- excavator structures, concrete pumps and aerial work platforms.
- highly loaded members where slenderness is required.
Welding S620Q requires a with low-hydrogen consumables, controlled heat input and preheat and interpass temperature management. The plate must be cut by plasma, laser or water jet; thermal cutting edges should be checked for hardening. Cold forming is possible but demands generous bend radii and careful springback control because of the high yield strength. All fabrication is normally done to an approved WPS with welder qualification per EN ISO 9606.
Q: What does the Q in S620Q mean?
Q indicates delivery in the quenched and tempered condition per EN 10025-6.
Q: How strong is S620Q compared with S355?
S620Q has a 620 MPa minimum yield versus 355 MPa for S355, about 75% more design strength, allowing much lighter sections.
Q: Is S620Q difficult to weld?
It needs a qualified welding procedure with low-hydrogen consumables and controlled heat input, but it is welded routinely in crane and equipment manufacture.
Plate from 3 mm to 100 mm is standard, with widths to 3000 mm and lengths to 12000 mm.
Q: Can S620Q be hot-dip galvanized?
Yes, but the zinc bath temperature and the steel's strength must be considered; consult the fabrication specification before treating.
Mill test certificates per EN 10204 type 3.1 or 3.2 with impact test results are provided with each delivery.



















